 Most viewed |
328 views
|
|
Tailpost plumb327 views
|
|
I precut all the vertical cap strip pieces previously, but the angles I did as needed by hand.326 views
|
|
Ready to tack326 views
|
|
As you can see it didn't take much to make the curve.324 views
|
|
Heating for the first bend324 views
|
|
Preparing to drill pilot hole in block. Note reference mark for alignment in jig 323 views
|
|
Getting ready to use the rib as a template to male the master nose rib.323 views
|
|
I used the nose piece as a template to mark the curve that goes on the end of the cap strip.322 views
|
|
Test fitting cross members for fuselage top321 views
|
|
After steaming, the capstrip is clamped in a form.320 views
|
|
Lifting the cap strip...320 views
|
|
| 333 files on 28 page(s) |
 |
|
|
|
|
13 | |
|
|
|
|
